Graphscad
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Graphscad

Graphscad : The Graphic Nodal Editor for OpenScad
 
HomeLatest imagesSearchRegisterLog in

 

 node_tube has wrong parameter names

Go down 
2 posters
AuthorMessage
ChrisLT




Messages : 45
Date d'inscription : 2017-01-30
Localisation : Newbury, Berkshire, England

node_tube has wrong parameter names Empty
PostSubject: node_tube has wrong parameter names   node_tube has wrong parameter names Icon_minitimeTue 14 Feb - 19:15

node_cylinder has helpful and correct parameter names 'top_radius' and 'bottom_radius'
node_tube has 'radius' and 'radius2' for the same. This is inconsistent not only with node_cylinder but with OpenSCAD which uses radius2 for the top, not the bottom.

By the way, in the absence of any documentation I don't know why tubes have both an inobject and a holeobject. If holemargin is positive the hole and the holeobject are bigger than the inobject. Why is this? Is it so you can make a tube and an object that fits inside it with a loose fit?
Back to top Go down
Admin
Admin



Messages : 59
Date d'inscription : 2017-01-08

node_tube has wrong parameter names Empty
PostSubject: Re: node_tube has wrong parameter names   node_tube has wrong parameter names Icon_minitimeTue 14 Feb - 19:59

thx. will fix names. will check about holeobject.... historical i think
Back to top Go down
https://graphscad.forumotion.com
Admin
Admin



Messages : 59
Date d'inscription : 2017-01-08

node_tube has wrong parameter names Empty
PostSubject: Re: node_tube has wrong parameter names   node_tube has wrong parameter names Icon_minitimeThu 16 Feb - 1:55

fixed. will be in next version
Back to top Go down
https://graphscad.forumotion.com
Sponsored content





node_tube has wrong parameter names Empty
PostSubject: Re: node_tube has wrong parameter names   node_tube has wrong parameter names Icon_minitime

Back to top Go down
 
node_tube has wrong parameter names
Back to top 
Page 1 of 1
 Similar topics
-
» callmodule doesn't show parameter names
» Function parameter name uniqueness not tested

Permissions in this forum:You cannot reply to topics in this forum
Graphscad :: Issues-
Jump to: